Jiangmen hino motors co., LTDsite！
Barrier gate Motor
Oil Pump Motor
The reason and treatment met..
What are the troubleshooting..
Why does the motor need acce..
What are the factors for the..
The reason and treatment method of the overheating of the gate motor
The high temperature of the gate motor during the working process will make the operation of the motor unstable or even cause it to fail to work. There are many reasons why the temperature of the motor is too high. We can deal with it according to the corresponding method to avoid its impact on production as much as possible.1. When the instantaneous voltage of the gate motor exceeds the rated voltage by more than 10%, or the instantaneous voltage of the motor is lower than the rated voltage by
What are the troubleshooting methods for motor heating faults?
When the motor temperature exceeds the high working temperature or the temperature rise exceeds the specification or the temperature rise does not exceed the specification, but the temperature rise suddenly increases at low load......
Why does the motor need acceleration and deceleration?
The reducer is actually a power transmission mechanism, which does not generate power itself. Its function is to use the different gear sizes and speed converters to reduce the number of revolutions of the motor (motor) to the number of......
What are the factors for the overcurrent of the air compressor motor?
A motor is a transducer that continuously converts electromagnetic energy and mechanical energy. When electrical energy is input, the motor can continuously output torque and mechanical energy......
The difference between plateau motor and ordinary variable frequency speed regulation motor
The mechanical equipment used in some areas with an altitude of more than 1500 meters needs to be equipped with a plateau motor to ensure the safety and life of the equipment.
Simple way to judge whether the motor is good or bad
1. How to check the quality of AC three-phase motor?1. Shake the watch, a 500V watch can be shaken, and the insulation resistance of the wires on the three terminals to the motor casing should be above 0.5M ohms, indicating that there is no short circuit to ground.
Causes of motor overheating failure
The motor is overloaded. Such as: friction between stator and rotor (commonly known as sweeping), unqualified assembly, and overload faults such as friction or jamming in the driven mechanical parts.
What are the common causes of motor damage?
The motor is a device that converts electrical energy into kinetic energy. It has many types. The phenomenon and causes of damage to different types of motors will be different, but to sum up, there are two categories: electrical and mechanical.
Why is the motor distribution cabinet always burning?
The power distribution cabinet is burned or ignited. I don’t know which one is. Is it the contactor that has been burned, or is it other components of the power distribution cabinet?
Tips for cleaning motor bearings
Mainly used for motor bearings hardened by soft dry oil or anti-rust paste, should be immersed in hot oil at 100-200 ℃, clamp the motor bearings with pliers, and use a brush to clean the oil stains on the motor bearings.
Total 28 1 records Current page / Total 3 10 per page
Jiangmen, guangdong taishan city TaiCheng board post water industrial zone no. 3 no. 1 floor
Copyright © 江门磁力天堂软件免费下载无限看电机有限公司